THIS SITE REQUIRES JAVASCRIPT TO BE ENABLED TO BE VIEWED CORRECTLY. PLEASE ENABLE JAVASCRIPT! INSTRUCTIONS

Monthly Archives: June 2013

Making the perfect, transportable rope swing

We’ve started  packing our homemade hammock and our rope swing on every campout and day trip. EVERY trip. In fact I tried to get my husband to leave it home a few months ago when we were packing for a trip to the Nevada desert. “Why are you packing these? You’re never going to hang a hammock, let alone a swing in the middle of nowhere.”

I was plesantly proven wrong on both accounts.

Joe has found places for hammocks and swings in just about every campsite we’ve been in this past year. It’s been a blast for the kids, so I asked him to write up a little tutorial on how to make and hang a rope swing.

MAKING YOUR SWING:

We use a disc swing as opposed to a traditional swing because it’s easier to hang. Only having one rope to hang means you don’t have to mess around with getting ropes even.

You can use pretty much any type of wood, as long as it will hold up to having someone sit on it. We’ve used 3/4 inch plywood or 3/4 inch particle board, both worked equally well.

Step 1: Trace the seat onto the wood, a 5 gallon bucket lid is the perfect size. Just set the bucket lid onto the wood and trace a circle around it

Step 2: Using a jig saw or something similar cut out the circle you just traced.

Step 3: Drill a hole in the center. There is probably a good way to find the center of the circle so you can drill a hole exactly centered in the swing but we always just eyeball it and it turns out fine. We use a 1 inch drill bit but a slightly smaller bit would probably work too, depending on the diameter of the rope you plan on using.

Step 4: (Optional) Seal the swing seat with some polyurethane or something like that.

Step 5: Attach a rope. There are two different way to do this pictured to the right.

Swing 1: Using about 6 feet of rope fold it in half, put the ends through the hole and tie a big knot.

Swing 2: Attach a short section of rope (about 3 feet) to the swing by stringing one end of the rope through the hole you just drilled.  Tie a large knot at each end of the rope. Be sure to tie a good knot that will not slip like a figure 8 or similar.

Step 6: On the other end of the rope tie a loop in the rope using a figure 8 or overhand knot (this loop will allow you to attach the swing to a fixed rope with a carabiner).

HANGING YOUR SWING:

I’ve used several types of rope and most work equally well. Static rope (without stretch) is better than dynamic rope (with stretch). In our yard we often use 1 inch tubular webbing because there is very little stretch and it sits flat against the branch so it rubbs less than most ropes.

There are several ways you can get your rope up in a tree:

Method 1 (photo to the right): Our preferred way to hang a rope is to climb the tree and tie the rope to a branch. Tie a loop in one end of the rope with an overhand knot, hang the loop on one side of the branch with the long tail hanging on the other side. Then underneath the branch thread the long tail through the loop and pull it tight. This method seems to secure the swing and minimizes the rubbing of the rope against the branch because the pivot point of the rope is against the loop rather than against the bark of the tree.

Method 2: If you can’t climb the tree, throw one end of a long rope over a branch (photo 1 below) and secure the other end to the base of the tree (photo 2 below).  The downside of this method is you have very little control over the exact location the rope hangs on the branch, and often this method leads to a lot of rubbing of the rope on the tree. Still, it work out fine in a pinch.

 

 

 

 

 

 

 

 

 

Once you have your rope up take the dangling end of the rope and tie another loop with an overhand knot and secure your swing to that loop with a carabiner. Depending on how permanent you want your swing to be, you can cut the rope to a desired length or simply tie up any extra rope above the swing.

We often tie several loops at the end of our rope at various heights (like this), the highest one for adults with long legs, a lower loop for middle sized kids, and a low loop for little kids. Then we use a carabiner to attach the swing to the desired loop.

Enjoy!

10 cool kid facts for a Full Moon night.

Did you know that the full moon is the only moon that comes up at sunset and goes down at sunrise? That’s precisely what makes it so perfect for night hiking. What could possibly spice a hiking up like walking in the dark of night with no need for a headlamp and your shadow trailing behind you.

Here are a few other kid friendly facts I’ve learned about full moons.

1. Is the moon really perfectly round? The full moon may appear round, but is actually shaped like an egg with the pointed end facing earth.

2. Why is the moon bigger as it’s coming up over the horizon? Well, it’s not. Scientists have long battled to explain the “moon illusion”. The phenomenon is understood to be caused by human perception rather than the magnifying effect of the earth’s atmosphere.

3. How often do we see a full moon? The full moon occurs every 29.5 days – the duration of one complete lunar cycle.

4. What’s the ‘Flower Moon’ all about? The full moon has many names. The Algonquian people had a different name for each full moon, depending on the month. Each name is linked to the season and nature. My favorite is September’s Harvest Moon, but did you know the Strawberry Moon is the name for the full moon in June? This is because strawberries are ready for picking. Here’s a list of moon names and meanings.

5. How long does it take to travel to the moon? The moon is about 238,855 miles from earth. Traveling by car that would take 130 days. If you took a rocket it would take 13 hours. And should you choose to travel at the speed of light, you could get there in a meer 1.52 seconds.

6. How fast does the moon actually move? The moon travels around the earth at an average speed of 2,288 miles per hour. Sure doesn’t look that fast! Why do you think that is…? I have a few theories.

7. Why is the moon so bright? It’s actually not, well, not really. The moon is not a light source, it doesn’t make its own light, it reflects light from the sun. We can see the moon because light from the sun bounces off it back to the earth. If the sun wasn’t there, we wouldn’t be able to see the moon.

8. Why does the moon change shapes, then sometimes disappears entirely? The moon appears to change shape but what we are actually seeing is the moon lit up by the light from the sun in different ways on different days. Check out this graphic from red-roko (to the right). It shows this perfectly.

9. Where does the phrase “once in a Blue Moon” come from? The second full moon occurring within a calendar month is called a Blue Moon. The latest was seen on 31st May 2007. And just to put this phrase into context, his phenomenon occurs once every three years on average. 

10. Why does the moon follow me? If you’re driving down your street at night, it may look like the moon is chasing you, zooming behind the treetops to keep up with you. The moon isn’t actually following you, though. It’s just an optical illusion. The moon appears to follow you because it’s so far away. As you walk or drive along, things much closer to you, like trees and houses, appear to move between you and the moon making it look like it’s the moon that’s actually moving.

  • WELCOME

    I'm Lindsey. I'm an environmental educator, my husband's a biologist. The outdoors is infused into everything we do; which explains why I'm better at mud pies than home decorating. More About Me

    I don't blog alone! Meet outsidemom contributer Olivia
  • KEEP IN TOUCH

  • PROUD TO SUPPORT

  • ACCESS ARCHIVES